Printing:

  • Printed Full Colour digitally via Over-printing.
  • Supply as actual size, press-ready PDF only, at actual size e.g DL is 220mm x 110mm (no reg. marks reqd); DL+ is 235mm x 114mm etc.

Best to keep 4mm clear zone all around.

ENVELOPE PRINTING ARTWORK NOTES:

  • NO registration marks are required. Supply as ACTUAL SIZE only (even if you have Bleed to the edge).
  • Set all artwork to CMYK (no Grayscale or RGB allowed as colour shifts will occur) for best results. Any existing spot colour Pantone ink references should be converted completely to CMYK only.
  • If picking any of the DL Window variants, you must leave 4mm Clear Zone around Window area!
  • Convert all Fonts to paths/outlines before making PDF.
  • Avoid text less than 5pt. Avoid Serif fonts under 6pt.

Printing cannot occur on any of the edges or creases, as the Envelope is Over-printed only (and not flat-sheet).

NOTE: Ink will run if it gets wet!

These are not intended to be used in continuous outdoor environment. Given the nature of envelopes, the paper and content should remain dry. Please manage your own or your customers' expectations in lieu.

Ink Coverage:

Standard 30% INK COVERAGE:

  • Usually that means a small company Logo block + text, or a partial tint with lighter colours over part of the canvas.
  • Majority of the envelope canvas is left blank White.

Size:

  • DL (220mm wide x 110mm high).
  • Flap is always at the top (wallet flap).
  • Save your PDF as actual size (NO crop or reg. marks!) at canvas size of 220 x 110 only.

Flap Type:

  • Flap depth on reverse is 34mm deep on 120gsm Peel & Seal.
  • Flap depth on reverse is 30mm deep on 100gsm Self-Seal.
  • Flap depth on reverse is 38mm deep on 90gsm Gummed.
  • All flaps are DOWN by default.
  • All flaps are Wallet (top, long edge) only.
 

PEEL & SEAL
120gsm P&S White – standard product

  • Flap depth on reverse is 34mm deep.
  • Peel & Seal Flaps are Top, Long-Edge Wallet.
  • Flap is DOWN by default.
  • DL Window variant has Window Dimensions of 93mm wide x 40mm deep, positioned 22mm from Left edge and 48mm from Top edge.
 

SELF-SEAL
100gsm S/S White – optional

  • Flap depth on reverse is 30mm deep.
  • Self-Seal Flaps are Top, Long-Edge Wallet.
  • Flaps are DOWN by default.
  • DL Window variant has Window Dimensions of 93mm wide x 40mm deep, positioned 19mm from Left Edge and 19mm from Base edge.
 

GUMMED MACHINABLE DL+
90gsm Gummed Mailing White – optional

  • 235mm x 114mm.
  • Trapezoidal Flap depth on reverse is 40mm deep at centre point.
  • Gummed Machinable Flaps are Top, Long-Edge Wallet.
  • Flaps are DOWN by default.
  • DL+ Window variant has Window Dimensions of 93mm wide x 45mm deep, positioned 51mm from Top Edge; 20mm from Left Edge and 18mm from Base edge.
  • 3mm WHITE Quiet Zone to be left around Window area.
*